Assigning Sources to Input Channels
Once Sources have been created, they must be assigned to input channels on the Quasar Engine and then saved to a Show Profile.
Show Profiles can be created in one of two ways:
Sources can be assigned directly from the console and the resulting configuration captured as a Show.
A Show Profile can be created from the web GUI by assigning sources to channels.
Creating a Show Profile from the Console
Push the top encoder of the channel strip to which you want to assign a source, then select the "Source" tab in the Master Touchscreen module.
All configured and active sources on the network will appear; it may be necessary to use the touchscreen to scroll down to show more sources.
Push the "Load Source" button.
Note - Inactive sources - that is, those generated by devices that are disconnected from the network or turned off - will not be detected by Quasar and will therefore not appear in the list.
Creating a Show Profile from the Web GUI
Using a PC connected to your studio network, enter the IP address of the Quasar Surface to display the web GUI.
Navigate to the Profiles menu, then to the Shows menu.
Click on the Create new show profile button.
Enter a name for the new Profile and confirm.
A new Show Profile diagnostics page will appear where Sources can be assigned to input channels from a dropdown menu.
For more detailed information on how to create and configure Network sources, please refer to the Quasar User Manual.
Last updated