Quasar Surface Network Configuration
Last updated
Last updated
Quasar Surface and Quasar Engine ship with the following default IP addresses:
Surface (Master) - 192.168.2.10
Surface (Modules) - 192.168.2.11, 192.168.2.12, etc.
Engine - 192.168.2.100
Should you need to change the default settings, or if you receive the warning message "No Connection to Engine" on the surface's home screen (just above the clock) once the system boot is complete, you will need to enter new network settings manually.
Access the System Setup page on the Master Touchscreen Module (MTS) by pushing and holding the "Monitor Options" key (labeled "MON OPT" and located between the two Control Room volume pots) for 5 seconds.
Enter the desired IP address and Netmask for the Surface and Engine using the touchscreen or the corresponding rotary encoders beneath the display. A Gateway is optional but typically not required when the console is part of a closed network.
Press the "Save & Reboot" button.
