Infinity Master Panel front panel instructions

  1. Locate light block displays

  2. Install each of the displays starting from right to left on the backside of the Infinity Master Panel Rear PCBA

  3. Ensure cable inserted properly before pushing down on the locking tab.

  4. Next carefully turn over the Infinity Master Panel Rear PCBA

  5. Secure the LCD screen to the Infinity Master Panel Rear. Ensure small white pegs are properly seated through the PCBA. ( Do Not Over -Tighten)

  6. Install the Infinity Master Panel Rear PCBA into the front panel bezel ensuring the connector J5 properly seats into its mating connector on the front panel assembly.

  7. Secure and install the Infinity Master Panel Rear PCBA to the front panel bezel assembly.

  8. Locate the Flat-Flex 6” 40-COND

  9. On the front panel assembly backside install the Flat-Flex 6” 40-COND at location J6.

    Note: Flat – Flex cable leads must be visible.

  10. Locate the Infinity 1Ru Faceplate Housing

  11. Locate Qty 3 Tinnerman Ball Stud 0.328” Male .218” Thread Length 1379-00024

  12. Install the ball studs into the backside of the Infinity 1Ru Faceplate Housing

  13. Slide the Locate the Infinity 1Ru Faceplate Housing over the front panel bezel assembly. Ensuring all three cables come through the Infinity 1Ru Faceplate Housing

  14. Next slide the Flat-Flex cable through the front of chassis.

  15. Snap the front panel assembly into the chassis and ensure the front panel assembly is flat against the chassis. The 3 Ball Stud should secure the front panel assembly after being fully seated.

  16. Install the Flat-Flex cable into J7 on the Infinity Main CPU PCBA