PHYSICALLY MOUNTING THE QUASAR ENGINE
Install your Quasar Engine in a suitable environment, like an air-conditioned machine room.
Make sure there is one empty position in your rack above and one below the engine. Air enters the unit from slots in the top and bottom of the front panel.
Connect mains cables to your Quasar Engine.
Your engine has dual, redundant power supplies. We recommend connecting these to different AC supplies. For example, do not connect these both to the same uninterruptible supply. If you are only plugging in one supply during configuration, unlatch the unused supply from the slot to prevent the alarm from sounding.
If your engine does not automatically turn on, push the ON/OFF (D) button on the front panel. At the end of the boot process, the four LEDs to the left of the front display could indicate errors due to missing sync, console not yet connected, or connection of a single Power Supply only. These error conditions are normal at this point.
SETTING AN IP ADDRESS
Push the green checkmark button (E) on the front panel to access the main menu.
The following screen is displayed.
Using the up and down arrow keys, select Engine IP Settings, then push the green checkmark button to select.
The following screen is displayed.
Push the UP/DOWN arrows buttons to select the Net Address field, and Push the checkmark button to enter edit mode.
Use the LEFT/RIGHT arrow buttons to select each digit and the UP/DOWN arrows buttons to increment or decrement the value. When complete, move the cursor entirely to the right and select the small "enter" symbol. Push the checkmark button to confirm the setting.
Use the arrow keys to move down and repeat for Net Mask.
Set the Gateway as needed.
Once on the Engine IP settings are entered, move the cursor down to [Apply] and Push the checkmark button.
The engine will prompt you with a request to reboot. Select OK and Push the checkmark button. Confirm your choice and reboot the engine to activate the new settings.
Continue to Checking connection to the Quasar Engine or go back to the Quasar Console Quick-Start Guide.