Home Page
Last updated
Last updated
Connect the Telos Infinity INF-MXP-20 to a network and either connect using the DHCP address automatically provided or enter the IP address manually programmed into the front Panel configuration. When successfully connected, the following will be displayed.
A user field to describe the operational use of the Panel. In this example its used in the Producers position.
Unique factory set number and cannot be changed.
User field to describe the physical location of the INF-MXP-20 to assist with system diagnosis.
User configurable IP Address Number set by the user from the front Panel control.
Unique Media Access Control address set in the factory and cannot be changed.
User configurable Gateway IP Address Number set by the user from the front Panel control.
Unique number set by the factory to identify the INF-MXP-20 and cannot be changed.
Set by current software version running on the INF-MXP-20. This is changed when software upgrades are loaded.
Describes the port state of the Precision Time Protocol interface running on the IP/Ethernet connection. This is either listening, slave or master depending on the configuration.
Describes the PTP master identifier. This is useful when multiple PTP master clocks are available in a BMC (Best Master Clock) redundant configuration.
Describes the time offset from the PTP master clock. This helps when configuring and diagnosing a system.
Internal temperature of the unit. To keep ambient noise as low as possible, the INF-MXP-20 does not use any cooling fans.
Number of days, hours, minutes, and seconds the INF-MXP-20 has been powered on for.
