Installing version 2.4.8a (final version)

Scope

This document applies only to the Telos Zephyr iPort PLUS Multi-Codec Gateway (iPort PLUS)

Description

The iPort Plus was replaced by the Telos iPort High Density Multi-Codec Gateway (iPort High Density).  This version represents the final update for the iPort PLUS

Note the physical appearance difference between the two.  The updates referenced here are ONLY for the iPort PLUS

Final Software Update

The final version of the iPort PLUS is 2.4.8a.  Note this version is released as “Patch” and was never shipped NEW on any iPort.  Click here to download version 2.4.8a to install on your iPort

If your iPort PLUS is running a current version OLDER than 1.7.1i you need an additional update FIRST.  Contact support if you are in this situation.

/Release notes for 2.4.8

• Bug #16057: Codec Livewire input canot load a ToSource if absent when iPort boots

• Bug #15079: Codec configuration page: Incorrect error message if using dual mono

• Bug #15080: LWRP. Cases when iPort sends unnecessary SRC indications.

• Bug #15081: Web UI.Unable to configure "No audio (GPIO only)" if channel configuration is set to "Dual Mono"

• Bug #15831: Content delay: incorrect TZD playback offsets

• Enhancement #15830: Update openssh to version 8.5p1

• Bug # 14851: Route is incorrectly added to the route table when B-path destination is in the same subnet as the B-path network.

• Bug # 14771: Some devices does not showing sources from iPort (advertisement issue introduced in 2.4.4)