Initial Configuration
The Telos Infinity INF-BP-2 ships from the factory unprogrammed. For the system to operate in static-IP mode, each Panel must be programmed with the IP, Mask, and Gateway addresses and the DHCP must be disabled. When first powered up from the factory, the DHCP will be enabled allowing the Panel to work in dynamic-IP mode.
Note - The next sections refer to Telos Infinity Dashboard. Dashboard is the software product used to program and configure Telos Infinity systems and is available from V2.0 as a free product called Dashboard Enterprise. Dashboard Enterprise is aimed at users who want regular live access to the devices but is equally suitable for users who require ad-hoc occasional use. Its operation and installation is described in detail within a dedicated section later in this manual under the section “Dashboard Software”.
Configuration of the IP addresses is best achieved using the front Panel “setup” menu and then the Dashboard software can be installed and run on a PC. During installation, great care must be taken to make sure IP address ghosting does not occur. That is, each device on the network must have its own unique IP address.
Once the IP, Mask, and Gateway addresses have been programmed, Livewire+™ AES67 automatically detects and registers connected Livewire+™ AES67 devices.
Note - Although it is possible to configure the system using the front Panel setup via the Dashboard software is much more convenient.
Please see the “INF-MP-16 Master Panel” and “Dashboard Software” sections for more information and to familiarize yourself with Dashboard before proceeding.
Front Panel Configuration
Menu
Menu Mode allows limited configuration changes to be made to the Telos Infinity INF-BP-2, though full configuration and programming is best performed via the web GUI.
To enter Menu Mode, press and hold the “Menu” key for 5 seconds. While the unit is in Menu Mode, the top of the display will display “Menu”.
Figure 4 - Menu Mode display
To exit the Menu Mode, either repeatedly select the “exit” option in each menu until the unit is returned to normal operating mode, or simply press and hold the Menu key again for 5 seconds.
To navigate the menu structure:
Rotate the Ch 2 volume encoder to scroll through the menu, parameters, and adjust the values.
Press the Menu key to accept ("take") the change in parameter or selection.
Menu Structure
The following options are available once the front Panel menu has been opened. Many of these options are also available from Dashboard.
