!!! WARNING !!!
Please read the following before installing the 2.4.7 update. There are new security features that could affect your update. The link to download the update is farther down in this document.
!!! WARNING !!!
Scope
This document applies ONLY to the original Telos Alliance xNodes and NOT to the newer xNode2 models.
Version 2.4.7 for xNode software requires some possible steps before installing. The steps only apply when updating to version 2.4.7 xNode software. If you are installing any version PRIOR, these instructions do not apply.
Description
Version 2.4.7 xNode software includes some new security features our customers have requested. Specifically, closing the SIP connection port (port 5060) and closing the main telnet port (port 23).
The SIP port's closing will affect your installation if you use SIP for unicast connections.
If you proceed with your install without un-configuring your SIP connections, you will be required to Factory Reset to restore fully functionality.
Check for and temporarily remove AES67 SIP Connections
If you have NO SIP connections an your Destinations page and you are sure you are not using AES67 SIP, you can proceed to the bottom of this page and download the update.
Before installing this update,
Navigate to the Destinations page on each xNode
Look for any Destinations that are using SIP Unicast connections
If you are using AES67 SIP, your Destination will be formatted like this. sip:8@192.168.2.114
Make note of, and remove, any SIP connections from your Destinations configuration page.
Click Apply.
Update your xNode software
You may now update your xNode software according to the previous instructions. Click HERE to download the update file.
Enable SIP Discovery
You must enable SIP Discovery before restoring your Destinations
On your xNode WebUI, navigate to the Synchronization and QoS link
At that bottom of that page, set the Enable SIP Disclosure setting to Enabled.
The default is DISABLED
Click Apply
Return to the Destinations page.
You may now return to the Destinations page and re-apply the SIP settings that we removed in the Previous Step.