The latest 9.SG Version 3.30.69 (changelog below), when run from a USB stick, has the DICE 200 update included:http://beta.zephyr.com/~tlscorp/pub/Omnia/O9/SG/Beta/omnia9sg_updater_3.30.69.pak First install the beta software in the normal way and then once v3.30.69 is running, put the same update file in the root of a USB flash stick, plug the flash stick into the front panel USB port.Run the updater from there by navigating to System / System Config / Software Update. (Note that you can install the beta via USB as well if you want)Scroll down, select "USB Update" and click to the right:
Scroll down, select "Run Updater" and click to the right:
When ready to proceed, select" Yes" and click to the right:
The S/W update screen should appear. Select "DICE 200 MBPS" and click to the right:
Follow the instructions on the screen.
Once the update is complete, remove power from the unit as instructed. Remove the USB stick. Restore power and then, once it boots up, you can check that it installed properly using the version number shown in System / System Status / Hardware Information. If the "Dice firmware version:" says "1000b", it is installed correctly:
Here's the changelog since the v3.20.04 release:
3.30.69:
RDS External Input phase issue fixed
IEEE-1588 PTP clock synchronization improved
Rewritten Livewire engine
New SNMP MIB, many issues corrected, now auto-generated
Dice Firmware version displayed under Hardware Info
RDS encoder UTF-8 translation implemented
MPX1/2 separate output delays added
RDS encoder letters É, È translation bug fixed
RDS encoder letter á translation bug fixed
Watchdog rewritten. The Dice chip now hard-resets if absent or unresponsive.
Hardware device presence now probed through HAL and logged.
Several specific error messages added to replace the generic "Engine Failure".
Mainboard Reset button added to System - System Config - Power.
Local input noise issue fixed
MPX input module moved to a separate thread to stabilize CPU load